You turn on the kitchen tap on a freezing morning and barely get a trickle. It worked fine the night before. Now you’re wondering if a pipe has frozen and how much trouble it’s going to cause.
Before trying to warm anything, check whether the other taps still work and look around for signs of a leak. A frozen pipe can crack without showing obvious damage until the ice begins to melt.
Here’s how to figure out what’s happening and what to do next.
What to Do First if Your Pipes Freeze
Start by checking a few things around the house:
- Try the other cold-water taps. If the kitchen sink has stopped working but the bathroom taps are fine, the problem is probably limited to one section of plumbing. If every tap is dry, the problem could be with the water line coming into the house.
- Look for signs of leaking water. Check around exposed pipes, under sinks, and along nearby walls or ceilings. A wet floor, dripping connection, or spreading water stain can mean a pipe has cracked.
- Find your main water shutoff. If water is leaking, shut off the supply right away if you can reach the valve safely. Even without a visible leak, know where the shutoff is before you start thawing anything.
How to Turn Off the Water to Your House
In most homes, the main shutoff is in the basement or crawl space, close to where the water line enters. If there’s a water meter in your basement, that’s a good place to start looking.
There are two common valve types:
- Round wheel handle: Turn it clockwise to close.
- Lever handle: Turn it a quarter-turn so the handle sits across the pipe instead of running alongside it.
Once you’ve shut off the water, open a cold tap to let the pressure out. Some water will still drain from the pipes.
Older shutoff valves can be stubborn, especially if nobody has touched them in years. If the handle is badly corroded or won’t turn with reasonable hand pressure, don’t force it. The last thing you need right now is a broken shutoff valve and water you can’t turn off.
Leave the municipal shutoff at the street or curb to the water utility. If water is reaching electrical outlets, appliances, or a panel, stay clear of the wet area.
How to Thaw Frozen Pipes Safely
If you can reach the frozen pipe and it’s not leaking or visibly damaged, try warming it slowly.
The tap that stops working isn’t always close to where the ice has formed. When we trace a frozen line, we look at where the pipe runs near outside walls or through colder parts of the basement. Sometimes a short stretch of pipe sitting in a draft is enough to stop water from reaching a tap in a perfectly warm room.
For an exposed pipe, open the affected faucet first. This gives water somewhere to go as the ice melts. Then apply gentle heat:
- Wrap the pipe in towels soaked in warm water, replacing them as they cool.
- Use an electric heating pad if the area is dry, following the manufacturer’s instructions.
- Use a hair dryer on a low or moderate setting, keeping it moving along the pipe. Make sure the area, cord, and outlet are completely dry.
Take your time and stay nearby. As the water starts moving again, keep an eye out for leaks.
Never use a blowtorch, propane heater, open flame, or boiling water to thaw a pipe. Too much heat can damage plumbing, and open flames around insulation or framing create a fire risk.
A frozen pipe inside a wall or ceiling is best left to a plumber.
What to Check Once the Water Starts Flowing Again
Getting water back at the tap is a relief, especially if you’ve been without it all morning. Before getting on with your day, give the area another look.
One thing we pay attention to is where a leak shows up after thawing. When ice blocks a pipe, pressure can build between the blockage and a closed tap. That pressure can split the pipe somewhere other than the frozen spot.
Check the exposed pipe and nearby fittings for drips. Look at the surrounding walls and ceilings too, especially if the line runs through a finished area.
If you shut off the main water, check for damage before turning it back on. When there’s no sign of damage, open the valve slowly and have someone watch for leaks. Leave the water off if a pipe has burst.
Check the other taps as well. One line thawing doesn’t mean every line in the house is clear.
When Should You Call a Plumber for Frozen Pipes?
Some frozen pipes are manageable on your own. Others aren’t worth taking chances with, especially when water is starting to leak or you can’t find where the pipe has frozen.
Call a plumber when:
- A pipe has cracked or water is leaking.
- The main shutoff valve is stuck or won’t close.
- The frozen pipe is behind a wall or ceiling.
- You’ve tried warming the pipe, but there’s still no water.
- The same pipe keeps freezing every winter.
- You notice dampness or water damage but can’t find the source.
If you’re on city water in London and none of the taps work, call City of London Water Operations at 519-661-4739. They’re available 24 hours a day and can help check whether the problem is with the water line coming into your home.
If you’re on a well and none of the taps are working, don’t assume it’s a frozen pipe. The problem could be with your well pump or pressure tank.
How to Stop the Same Pipe From Freezing Again
Once the pipe has thawed, take a look at what made that spot so cold. Drafts along a foundation wall and unheated garages are common trouble spots.
When the same pipe freezes year after year, we look for where cold air is getting in before deciding what needs fixing. A pipe can be wrapped in insulation and still freeze if there’s a gap in the foundation letting cold air blow across it.
Sometimes sealing that gap does the trick. Other times, the pipe needs to be moved somewhere warmer to keep the problem from coming back.
For a sink on an outside wall, opening the cabinet doors during a cold snap helps warmer room air reach the plumbing.
Frozen Pipe Repair in London From Plumbing For Life
Losing water on a freezing morning is frustrating enough. Finding a leak after the pipe thaws can be even more worrying, especially when you can’t tell where the water is coming from.
If that’s what you’re dealing with, give Plumbing For Life a call. We’ll take a look, explain what’s going on, and go over the repair and the cost before we start. We can also check why that section froze and help you avoid the same problem next winter.



